Victor Holdfast Rat Traps M326 - 6 Traps

Rating:
100% of 100
$22.99
In stock
SKU
RT002

Made from FSC certified wood the Victor Mouse Traps are very sturdy and long lasting. The snap wire part of the Victor Mouse Trap is so strong that it could even break your finger. Mice are naturally curious so if you place a piece of bait on top of the plastic triggering which is more sensitive than metals ones it will trap your rodent right away. When placing the trap make sure it is perpendicular to the wall, so that the trigger end is towards the wall on the hard surface.

Victor Holdfast Traps (M326) / Rats

The Best Rat Traps - Victor Rat Trap are made from FSC ceritfied wood. The snap wire part of the Victor Rat Trap is strong enough to break your finger. Rats are naturally curious so if you place a piece of bait on top of the plastic triggering which is a lot more sensitive than metals ones it will trap your rodent at that point. When placing the trap make sure its perpendicular to the wall, so that the trigger end is towards the wall on the hard surface.

Target Pest(s): Norway Rats, Roof Rats, House Mice and other Rodents
Manufactured By: Victor
Size: 7" x 3 1/4" x 1/2"

Victor Holdfast Traps: Wire snap trap with large scented plastic trip pedal is made with FSC certified wood. No bait needed. Mice and rats are naturally curious to their environment, and the interesting looking plastic trigger that is more sensitive than normal metal trigger will be released when these rodents come near to inspect. Place the traps perpendicular to the wall, so that the trigger end is towards the wall on a hard surface. It is important to set the trap in an area with a lot of mice activity, for instances, areas where you see a lot of droppings, urine stains, rub marks, etc. Place as many traps as possible, making the traps seem like part of the atmosphere, to bring out best results. One the tricks you could try is to make rodents friendly with these traps, placing unset traps out for about a week with bait on it then setting the trap later will increase your opportunities. It is suggested not to set the traps on machinery surfaces that can vibrate and release the traps. Caution should be taken when using around children or pets--the snap is very strong and could cause bodily injuries.

Write Your Own Review
You're reviewing:Victor Holdfast Rat Traps M326 - 6 Traps
Your Rating

Do You Have a Question about this Product? Ask Our Experts!


Q. how do i set the trap?
A.  The bow (spring loaded part of the trap) is carefully pulled back and held down with the thumb. With your free hand, take the locking bar (the long arm of the trap with the curve at the end of the arm which is attached to the back of the trap) and lay it on the center of the bow. you must make sure that the curved or cupped part faces downward. As you begin to tilt the yellow plastic pedal upwards, you will see that the tip on the locking bar will lock inside a box opening in the back of the yellow pedal. Carefully and slowly release your thumb grip on the bow. As you release the bow and hold the trap, be careful not to have your fingers in areas where the arm can snap for precaution. *NOTE* There is an "S" and an "F" imprinted on the pedal itself. If you wish the trap to be more sensitive, position the locking bar towards the "S" side of the little box by sliding it that direction. "F" stands for firm (less sensitive).
Was this helpful?
Yes
4
Votes